Gun Collectors Dream Auction 63 Day Two
Lot 1106:
Here we have a Very Nice & Clean R.F.I. Enfield Rifle Chambered in 7.62 and appears in all original configuration, good furniture, 118 Rack Mark on the Left side of the stock, Comes WIth One Magazine, and Oiler and Pull Through in Stock, On the right side of the reciever it is marked as follows: Crown – Rifle 7.62MM 2A R.F.I. 1965. Findings from the internet below: The Rifle 7.62mm 2A/2A1 (also known as the Ishapore 2A/2A1) is a 7.62?51mm NATO calibre bolt-action rifle adopted as a reserve arm by the Indian Armed Forces in 1963. The design of the rifle – initially the Rifle 7.62mm 2A – began at the Rifle Factory Ishapore of the Ordnance Factories Board in India, soon after the Sino-Indian War of 1962. The Ishapore 2A/2A1 has the distinction of being the last bolt-action rifle designed to be used by a regular military force other than specialized sniper rifles. Externally the Ishapore 2A/2A1 rifle is based upon (and is almost identical to) the .303 British calibre SMLE Mk III* rifle, with the exception of the distinctive ?square? (10 or 12 round) magazine and the use of the buttplate from the 1A (Indian version of the FN FAL) rifle. The 2A was designed to allow the British Pattern 1907 (P’07) sword bayonet used on the SMLE MkIII to be attached. There were other differences to the Ishapore 2A/2A1 rifles that include the use of improved steel (to handle the increased pressures of the 7.62mm NATO round), and a redesigned extractor to cope with the rimless round. Production of these rifles started in early 1960s and is believed to have been discontinued in 1975. The original (2A) design incorporated the Lee?Enfield rear sight which has graduations out to 2000 yards. The re-designated "Rifle 7.62mm 2A1" incorporated a more realistic 800 meter rear sight. The stock is recycled from the No. 1 Mk. III armory stock, with the addition of a cross screw forward of the magazine well. Some stocks were salvaged from existing surplus and show artificer repairs where rotted or damaged wood has been replaced. This repair is especially evident with the recoil draws (the area the receiver contacts when recoiling after the shot) that often failed over time due to the rifle being rack-stored butt down / muzzle up, which allowed oils and grease to migrate downwards into this critical area.
Share this lot:
Powered by Brand Used Works
